Diy Chain Link Fence Drag

Cut a piece of 3 8 inch rope to approximately 6 feet long.

Diy chain link fence drag.

Cut a piece of chain link fence down to 6ft. I never tried a pallets on top but it sounds like a good idea. Go with chain link with weight and it will work fine. Second place the chain link fence section on a flat surface.

If you have enough fence just roll most of it up and wire it so it won t unroll. How to make a drag from chain link fence step 1. Here is a quick rundown of how to make a chain link drag mat. Tie one end of the rope to the left side of the 4 foot width of.

Lay an appropriately sized chain link fence on the surface. Three steps of making a functional chain link drag mat first select a piece of chain link fence. Lay the section of chain link fence 4 feet wide by 6 feet long on the ground. The overall length can be.

The bar makes the end of the fence rigid and provides something to attach to the posts. Right behind it is a 4 foot section of chain link fence slightly weighted down with old tires. Now cut a 3 8 rope to the desired length 6 feet long in this case. Run a tension bar through the links at the end of the mesh.

I use a chain link fence for a drag on my food plots. Just enough to cover the seeds and close any disk grooves. It should not take alot of weight to grag the planted area. I found chain link woorks very well with a fence post or two on top to keep it on the ground.

A 4ft x 6ft width by length drag works for a start though you can make it longer than 6 foot as per your needs. Chain link fabric or mesh is usually sold in rolls 4 5 or 6 feet high. It s pretty heavy rolled up. Lay the chain link mesh on the ground outside the fence.