Polyurethane foam concrete raising is a cost effective alternative to replacing concrete.
Diy concrete lifting foam.
You can avoid this expense if you do it yourself with the help of a jacking pump which can raise the concrete slab to the needed level.
Drill a hole.
Watch how we lift and level this sinking driveway with foam.
Lifting a sunken slab may be necessary to level the surface.
Demilec a company located in texas has invented a type of insulation foam that can help all of the cracks and uneven pavement problems.
Hack to fix sunken concrete.
Fast setting concrete is necessary to patch the holes when you re finished filling them up.
However the savings may be even greater since when concrete raising the costs of demolition removal and landscaping are eliminated.
The driveway had sunk 4 and we saved it from being replaced.
Geolift works for driveways sidewalks patios garage floors even pool decks.
Unfortunately back fill around a foundation i.
Use the brick chisel and sledgehammer to undercut any edges of the sunken concrete as necessary.
Place chalk marks in a row on the slab extending from the low point to the beginning point of the slag spacing.
How to raise concrete with foam step 1.
With a concrete drill or masonry bit drill small holes into the sunken area and slowly pour a thin mixture of cement into the holes.
Over time it is not uncommon for concrete slabs to sink or settle especially if poured over an unstable base.
You should also get a steel.
Geolift can help to lift existing concrete surfaces and fix those problem areas around your house with much less labor.
Allow it to stand for half an hour so that it can settle.
Hiring a professional service to lift or jack up the slab can be costly.
This is another method for doing it yourself.
Locate the point at which the slab begins to sink into the soil by placing a carpenter s level onto the surface.
Concrete raising can usually be done for less than half the cost of pouring new concrete.
Otherwise you could crack the concrete.