Diy Remove Wall To Wall Carpet

Pulling up carpet depends on the reason the carpet needs to be pulled up.

Diy remove wall to wall carpet.

Protective gloves should be worn to protect hands from staples and while cutting the carpet and handling tack strips. When the corner of the carpet is loose use your gloved hands to pull along the length of the wall. If the goal is simply to get the old carpet out of the way protect your hands with heavy gloves and use a sharp utility knife to cut a border around the entire area about four or five inches away from the walls. Old carpet can be full of dust so be sure to wear a dust mask.

Pull up a few feet of carpet and fold it over. Make sure it is taught. How to install a carpet runner on wooden stairs installing a carpet runner using tackless strips adds color and comfort to stairs and can be accomplished by a diyer of any skill level. Take a look at the room and check to see that your wrinkles have been removed from the carpet.

Using an automatic or electric stretching machine stretch the carpet in place. Diy experts show how to install wall to wall carpet in any room. Use pliers to pull each staple from the subfloor image 2 then place staples into disposable plastic cup. Keep both hands on the knife to avoid cutting a free hand.

Step 7 stretch the carpet. Once all of the carpet has been removed it s time to remove the padding following the same steps outlined above image 1. Roll or fold the strip secure with duct tape and remove it. The most time consuming step in the process is removing staples.