Do Prime And Paint Cut Ends Of Truwood Siding

Do not miter sides edges of trim.

Do prime and paint cut ends of truwood siding.

The back side is better left unpainted. Back priming helps prevent paint from peeling by reducing the amount of water vapor that passes through the wood. Therefore do not prime the back side of the siding or trim. Watch this video to find out more.

If trim is cut to fit around door and window openings raw edges. All it takes is a little can of paint or sealer. Spray cans or primer or disposable cans and brushes with primer can be used to prime the end grain once installed. Provide a 1 in.

2018 2015 2012 2009 international. Clearance between the gutter end and trim see fig. Do not paint in wet or cold conditions. Once the siding has been installed apply two coats of a top of the line latex exterior house paint to it.

Priming and sealing end grain during the wood siding deck or trim installation can be easily accomplished and does little to slow down a job. Cutting cut with conventional tools into the face to be exposed. According to the terms of lp s application instructions all exposed edges of lp smartside siding and trim must be primed and painted with approved paint to protect the siding substrate. When back priming be sure to prime the ends of each piece after it has been cut to fit since end grain will absorb the most moisture.

I would strongly suggest priming the front back edges and ends of your pine siding with an oil based exterior primer before installation. Use high quality waterborne 100 acrylic exterior paints apply a finish coat within 180 days of installation do not paint wet siding ensure the surface is clean dry and free of any dust dirt or mildew do not use. Roof and gutters are adjacent to the siding. Make sure to prime and paint all exposed cut edges.

Do not bevel cut the siding edges at butt joints.